Set Project look 3: Ignite digital process

 The first step was to draw the sketch, scan it and then put it on Photopea to start the digital process.

The first step was to clear out the black lines using hard mechanical brush in white with opacity 100% and 12px size. Later on I chose a colour which was light to medium red. Then i chose the brush tool and selected soft mechanical size 10px and 92% opacity. I filled in the top in as shown below.

For the outline after erasing with white the excess red, i chose another colour as shown in the colour palette in the previous post and chose size 3px, hard mechanical brush and opacity 80%.

For the inside shirt which had to be a bit see through, I chose soft mechanical brush, 12px size and opacity 68% and filled that in.

 For the skirt i filled it in again and erased the excess and went over with the same outline instructions but before that i chose the same red as the top but in 78% opacity, 12px size and brush hard mechanical. For the shoes as indicated below i chose a red colour with opacity 100%, size 8 px, brush tool wet shader and switched to sketching medium.

For the skirt outline I switched to 3px, hard mechanical brush tool and opacity 56%.

For the bag i chose a new colour, brush wet shader and opacity 78% for the star flame inside. For the layer inside i chose 100% opacity, 10px size and hard mechanical tool and then switched to 54% opacity 60p0x for contrast and then switched again to 73%.